|
Adding Digital SP-DIF to Advanced A/V pack (v0.1) |
|
|
My receiver has 1 optical and 1 digital coax input. I wanted to keep the optical for my DVD player so I needed a SP-DIF not an optical output from my Xbox. Still the advantage of going with the Advanced A/V pack is you don’t have to open up your Xbox if anyone is worried about that ;-)
This is very simple and done similar in 2 other tutorials so I won’t go into too much detail just good pics. Parts-
RCA jack that mounts to a panel
2 wires 1. remove these 3 screws and remove cover
2. remove screw holding in PCB
3. I chose to put my RCA jack here since there’s plenty of room
4. drill your ¼ hole for the RCA jack
5. solder 2 wires to the board - Pos/digital signal and GND
6. mount your jack, wire it in – signal/pos is middle
7. put back together DONE
a nice clean looking Digital SP-DIF connection while also keeping your optical. Both still work. 
Thanks to DataBitz, and Smokewagon |
Only registered users can write comments.
Please login or register. Powered by AkoComment 2.0! |
Tutorials 
